We’re on the Cutting Hedge.5% off for pensioners07763 100 477 · hello@littlebournehedges.co.uk
Littlebourne Hedges & Tree ServicesLittle Stour Valley

← All guides · Trees · Updated November 2026

Tree pollarding in Littlebourne: the decision route.

Pollarding is one of the oldest tree-management techniques in the landscape, and the willows along the Little Stour have been managed this way for centuries. But it is a long-term commitment that can go badly wrong when started on the wrong species or at the wrong stage. This decision route works out whether pollarding is right for your tree, whether you can start one, and what has to happen before any cuts are made.

Step 1: what is the current situation with your tree?

An established pollard with years of heavy regrowth that has become too large or structurally risky → this is the most common situation. The tree has a pollard knuckle (a swollen boss of old cut-points on the trunk), and what you need is a re-pollard back to those knuckles. Skip to Step 3 to check for legal protection, then Step 4 for timing. The cuts here are well-understood and predictable: cut back to the established points and the tree will respond normally.

A young tree where you want to establish a new pollard from scratch → this is the right approach when the tree is still manageable height and you want to keep it at a fixed height long-term. Willows, limes, hornbeams and field maples are well-suited to this. Go to Step 2 to confirm species suitability, then Step 3 for legal checks, and Step 4 for timing the first cut.

An older, mature tree that has never been pollarded and someone is suggesting starting now → this is the highest-risk situation. The RHS is clear that pollarding is best started on young trees; attempting to impose a pollard regime on a large, mature tree that has not previously been managed this way puts serious stress on the tree and the structural outcome is unpredictable. Get a specialist arborist opinion before agreeing to any such work. If the tree is simply too large, crown reduction is usually the safer operation, see the crown reduction decision route.

A conifer, Leylandii, Lawson cypress or Western Red Cedar → pollarding is not suitable. Conifers do not regenerate from old wood. The correct question for these species is whether a staged height reduction is feasible (while green growth remains on the outer shell) or whether removal is the only realistic answer. See the leylandii reduction route or the Lawson cypress guide.

Step 2: is this species suitable for pollarding?

Willow (Salix), including crack willow along the Little Stour bank → the classic English pollard. Willows take to it readily at any size, respond vigorously from the knuckle, and need re-pollarding every one to three years to keep the new growth manageable. Willows near water carry an elevated risk of branch failure if re-pollarding is left too long: the regrowth becomes heavy and the attachment to the knuckle is weaker than a naturally grown union.

Common lime or small-leaved lime (Tilia × europaea, Tilia cordata) → well-suited, one of the most reliably pollarded trees in a formal setting. Many of the lime avenues in older gardens in and around Bekesbourne and Patrixbourne are managed this way. The cycle is typically every two to five years.

Hornbeam (Carpinus betulus) and field maple (Acer campestre) → both respond well and are genuinely common in CT3 hedgerows and garden boundaries. Field maple is the most widespread native tree in the Little Stour valley and tolerates a wide range of management. Hornbeam is a traditional pollard in historic parkland settings.

Oak (Quercus robur) and ash (Fraxinus excelsior) → both have deep traditional associations with pollarding in English landscapes. Ash should not be pollarded without an ash dieback assessment first; see the ash dieback decision route. Oak pollards are long-term commitments and usually only make sense on trees that are already established pollards.

Cherry and other Prunus species → possible but carry a heightened risk of silver leaf disease if cut outside the dry summer window. If a cherry must be pollarded, limit the work to dry weather between late June and early August. Any large wounds on cherry should be treated with a wound sealant.

Yew, box, holly and other dense-foliaged amenity trees → these are more naturally managed by tight annual clipping than by pollarding. Formal shaping and topiary are the appropriate route. See the yew pruning guide.

Step 3: does this tree have any legal protection?

Tree protected by a Tree Preservation Order (TPO) in Canterbury City Council’s area → a formal application to Canterbury City Council is required before any work begins. There is no minimum-size threshold for TPO-protected trees. Pollarding is typically granted for established pollards being maintained under their existing regime, but starting a new pollard on a protected tree requires a detailed description of the proposed cuts and clear justification. The Canterbury City Council TPO register is searchable via its work to trees page. We check the register as part of every tree-work quote.

Tree in Littlebourne’s conservation area, or in a neighbouring Little Stour valley village’s conservation-area boundary, where the stem exceeds 75 mm diameter at 1.5 m height → six weeks’ written notice to Canterbury City Council is required under section 211 of the Town and Country Planning Act 1990 before any cutting begins. For pollarding, the notice should describe the proposed work as "pollarding back to established pollard knuckles" or, for a first pollard, "first pollard at [height] metres above ground level." The full process is in the guide to tree work in the conservation area.

No TPO and no conservation-area designation → no planning or notice requirement. The nesting-season check in Step 4 still applies.

Step 4: is the timing right?

Late winter to very early spring (November to February) → the standard window for most pollarding work. The tree is dormant, the branch structure is fully visible, and cuts begin to compartmentalise before the spring growth flush. The RHS notes that autumn is the least favourable time for pollarding because decay fungi can colonise fresh cuts during the season when spore loads are highest. Avoid October and November if at all possible.

1 March to 31 August → this window overlaps the nesting season under the Wildlife and Countryside Act 1981. Pollarding removes large amounts of branch structure, which often includes nesting sites. A competent visual nest check immediately before any cutting begins is a legal requirement. Many field-boundary trees in Littlebourne and the surrounding Little Stour valley villages carry active nests through April, May and June. If a nest is found, work must stop until the nest is confirmed clear. See the nesting-season decision route.

Cherry and other Prunus → if pollarding must happen, dry summer weather between late June and early August is the safest window. This reduces the risk of silver leaf disease entering the wound. Keep cuts clean and do not work on wet days.

Willow → willows can technically be pollarded at almost any time of year, but winter remains the preferred window to reduce the risk of fungal pathogens entering the cuts. Willows along watercourses such as the Little Stour also need to be assessed for water vole burrows at the base before any heavy footwork or machinery near the bank; this is good practice, not a legal requirement in most cases, but it is worth a brief look.

Step 5: what does the ongoing cycle look like?

Willows and fast-growing species → re-pollard every one to three years. Leaving willow regrowth beyond three to four years allows the new branches to become heavy enough that their attachment to the pollard knuckle becomes structurally unreliable. A willow on a river bank that is left for a decade risks dropping large branches into the watercourse or onto anyone below.

Limes, hornbeams, field maples → every two to five years is a workable cycle for amenity trees in a garden or avenue. The longer the gap, the larger the timber removed in each operation, which increases cost and stress to the tree. A five-year cycle suits most garden settings; a two-year cycle suits a formal avenue or a tree in a constrained space.

Gaps of more than five to seven years on an established pollard → the regrowth has become large enough that the operation moves from routine management into a more significant surgical job. The branches are heavier, the wounds will be larger, and there is a higher risk of the tree going into shock or producing excessive epicormic regrowth. If the pollard has been neglected for ten or more years, treat it as a specialist job and get an arborist assessment before quoting a standard re-pollard.

Ancient or veteran pollards → some of the older willows and field maples in boundary hedges along the Little Stour corridor, and around Lee Priory and the former watermill sites, may qualify as veteran trees. These should be assessed by a specialist before any work, as the management of a veteran pollard is a different discipline from routine re-pollarding: the timber volume that can safely be removed in one operation is much smaller, and the wildlife interest (bats, lichens, deadwood invertebrates) may be significant. Contact Natural England or the Bat Conservation Trust if any bat roost is suspected.

Not sure whether your tree is a good candidate for pollarding, or whether a TPO or conservation-area notice applies?

Call 07763 100 477 or email hello@littlebournehedges.co.uk with a description of the tree and your postcode. We carry out the TPO and conservation-area check as part of every tree-work quote, file any notices on your behalf, and include a nest check before any cutting begins.

If the question is whether the tree needs a size reduction rather than a pollard, the crown reduction decision route covers species limits, the topping trap to avoid, and staging the work safely under BS 3998.

For an overview of all the crown operations, see the tree pruning decisions guide.

Lime trees managed as a pleached row or hedge-on-stilts structure need a different annual routine from full pollarding. The pleached lime and hornbeam pruning guide covers the formative training and maintenance decision route for those structures.

Sources: RHS – Pollarding; Woodland Trust – Types of woodland management; Wildlife and Countryside Act 1981, section 1; Town and Country Planning Act 1990, section 211.