Tree work in Littlebourne's conservation area: the decision route to getting permission.
People ask us for a conservation area permit to prune a tree. Strictly, it is not a permit: it is a notice to Canterbury City Council, sent at least six weeks before the work, with no fee. Whether you need to send one depends on a handful of yes-or-no questions. Work through them in order.
Step 1: is your address inside a conservation area?
Your property is in Littlebourne village → probably yes. Canterbury City Council lists a Littlebourne conservation area and a separate Elbridge House (Littlebourne) one. Check the exact plot, not just the street. Use the council's conservation areas page and its Planning Constraints map. The council also publishes appraisals for Littlebourne and Elbridge (PDFs), which explain why they are protected.
Your property is in a neighbouring Little Stour valley village → Canterbury City Council is the authority there too, and its list of 97 conservation areas includes areas for other villages in the valley. Check the map for your own plot.
The map shows no area over your plot → no conservation-area notice is needed. Go to Step 3 only if there may be a TPO, and otherwise the nesting-season rules in the nesting check are the main constraint.
Step 2: is the plant a tree under the rules?
The rule is section 211 of the Town and Country Planning Act 1990: six weeks' notice before cutting down, topping, lopping, uprooting, wilfully damaging or wilfully destroying a tree. The test is trunk size.
The trunk is over 75mm across, measured over the bark at 1.5m above ground → it needs notice for any of that work, whatever the species. Hornbeam, beech, field maple, ash, holly, yew, leylandii, laurel: native or non-native, evergreen or deciduous, if it is a tree and over the size, it counts.
The trunk is 75mm or less → no notice for cutting down, topping, lopping or uprooting. There is a 100mm limit as well, but only for cutting down or uprooting to help other trees grow (thinning), not for pruning.
It has several stems at 1.5m → if any one stem is over the limit, the exception does not apply.
It is a clipped hedge plant, not a tree → shrubs are not normally treated as trees, so ordinary trimming of the hedge itself is not what the rule is for. The government guidance does say trees in a hedge, or an old hedge that has grown into a line of trees of reasonable height, can be treated as trees. If you plan to cut thick old stems hard back, ask the council first.
How to measure it → put a tape round the trunk at 1.5m and divide by 3.14. Say an ash standing in a hedge runs to 29cm round: 29 divided by 3.14 is 9.2cm, so 92mm, over the line. At 22cm round it would be 70mm, under it. If it is close, measure twice.
A worked example → a garden backing on to the Little Stour, with a hazel and hawthorn boundary hedge and one ash standing in it. The hazel and hawthorn, clipped every year, are ordinary hedge care. The ash, at 92mm, is a tree over the limit, so any crown work on it needs notice. Ash dieback does not change that: a dying tree is not the same as a dead one (Step 7).
Work that is exempt even on a tree over the limit → dead or dangerous trees and branches, work needed to carry out a full planning permission, work to prevent a legal nuisance (the minimum necessary), work required by an Act of Parliament, and pruning fruit trees grown for fruit in line with good horticultural practice. Removing dead branches does not need approval, but the council's guidance asks for five days' warning if you can give it.
Step 3: does the tree already have a TPO?
Yes, a Tree Preservation Order applies → the normal TPO rules apply instead. You need the council's consent, not a six-week notice. The Planning Portal says a TPO overrides the conservation area. The council's map, which it labels “Check if a tree is protected”, shows them, and its work to trees page has the TPO route.
No TPO shown → continue to Step 4.
Step 4: what exactly do you want done?
“Cut it back a bit” → too vague. The council's guidance notes (PDF) say “cut back”, “lop” or “trim” does not say how much.
Thin the crown → give a percentage of leaf area. The council says more than 30% is likely to be refused.
Lift the crown → give a height above ground.
Reduce the crown → give the overall height and spread you want at the end.
Photograph the whole tree and the branches concerned before anything changes.
Step 5: gather what the council asks for
Species → if you know it. A common name will do. Sketch plan → boundaries, house, road, the tree numbered, and any nearby trees you are not touching marked as such. Works and reasons → tree by tree, using the numbers on your plan. Photos and contact details → marked up to show which tree is which, plus the date: the government guidance says a notice must carry the date it is submitted. One notice can cover several trees, several operations and phased work.
Step 6: send the notice
Use the Planning Portal route → Apply to do work to a tree in a conservation area, which is the link on the council's work to trees page. The Planning Portal's works to trees page confirms there is no fee, and its guidance note (PDF) helps with wording.
Tree 1 (ash, 92mm at 1.5m, rear boundary, marked 1 on the plan): crown reduction by about 2m to an overall height of about 10m, to clear the shed roof and the electricity service. No work to the hazel and hawthorn hedge (not trees). Photographs attached.
Step 7: dead, dying or dangerous?
The tree is dead → the government guidance says to give the council five working days' written notice before the work.
It presents an immediate risk of serious harm → you can act at once, with written notice as soon as practicable afterwards. Photograph it first.
It is only dying or diseased → not the same as dead. It needs the normal notice unless another exception applies.
A replacement tree can still be required in the dead and dangerous cases.
Step 8: the six weeks, and what happens after
The council makes a Tree Preservation Order → the tree is protected and you would need consent under that Order. You may still apply for it at any time.
The council writes to say you can go ahead, or says nothing for six weeks → you may do the work within two years of the date of the notice, and only what the notice describes. It cannot refuse or attach conditions, because a section 211 notice is not an application.
You want to start before the six weeks are up → only if the council has told you that you may.
Whatever the outcome → keep the confirmation and any reply, give your contractor a copy, and check for nesting birds if the cutting falls between 1 March and 31 August (Wildlife and Countryside Act 1981, section 1). Breaking section 211 is an offence: up to £20,000 in the magistrates' court and unlimited in the Crown Court, plus a duty to replace a tree removed in breach. For other tree work decisions see the tree pruning decision route.
Not sure which trees in your hedge need notice?
Send a photo (with a tape or a stick in shot) and your postcode to hello@littlebournehedges.co.uk, or call or WhatsApp 07763 100 477. We will look at the hedge, tell you which trees would need notice and which would not, and once the notice period has passed we will do the work. We do not offer hedge removal or stump grinding.
Tree over the road and a council notice with a short deadline? Received a section 154 notice? What to do, including what to check before pruning a protected tree.
If the tree also appears on Canterbury City Council’s TPO map, the section 211 notification is not enough on its own: a separate consent application is needed. See the Tree Preservation Order permission decision route for the application process, exemptions and timescales.
Sources: GOV.UK, Tree Preservation Orders and trees in conservation areas; Town and Country Planning Act 1990, section 211; Planning Portal, trees; Canterbury City Council work to trees and conservation areas pages (checked 30 September 2026); Wildlife and Countryside Act 1981, section 1.